I've nearly finished the brackets which mount the radiator. These are just some 30mm wide strips of stainless steel which are bent and drilled to bolt the rad on. I kept the nose cone close by to check for internal clearance. I intend to finish these brackets tomorrow.
An inlet manifold has been ordered from Bogg Brothers. I need to mount this before I can make the brackets for the alternator and I need to mount the alternator to check how much room is available for the steering mod.
An inlet manifold has been ordered from Bogg Brothers. I need to mount this before I can make the brackets for the alternator and I need to mount the alternator to check how much room is available for the steering mod.
No comments:
Post a Comment