More on rear lights

I'd finished off the twin light clusters ready to mount the lights themselves but then found that the screws that were included in the set were too small for the pre-drilled holes in the clusters. To get round this I used some M4 screws but had to remove the clusters once more to get a spanner on the M4 nuts. All put back together and with the lights wired in to the premier loom, I'm pleased they all work. For the rear number plate light, I took a feed from the near side tail light.

Hazards on:

Tail lights on:

I then set to work on the fog light. The supplied housing needed some cutting so that the fog light is vertical, a requirement of the IVA test. This is now mounted but not yet wired in.